Ambient Recording ACD 201 Manual - Página 12

Navegue en línea o descargue pdf Manual para Equipos de grabación Ambient Recording ACD 201. Ambient Recording ACD 201 20 páginas.

In Reader / Generator Mode

The generator cannot be loaded in the Reader/Generator mode.

Select Generator Mode, then Load the generator and change the

dipswitches back to Reader/Generator Mode. (Dipswitch pos 4.5.

goes from Off. Off to On. Off)

When rejamming generator change dipswitches to generator mode,

rejam and change dipswitches back to Reader/Generator.

Note: We recommend that the slate is used as master in this mode. It is easier to

rejam the camera and recorder than changing the slate's dipswitches each time.

2.3.12

Setting the realtime Clock (RTC)

The RTC can only be set with the slate in generator RTC mode

To enter values from running generator,

Go manual set mode.

Check that userbits have DD.MM.YY.XX format

move cursor to FF position without changing the display.

Select ct.

Load by pressing both buttons till display runs.

To enter values from selected display

Go manual set mode

Enter date

DD. MM. YY.XX

Enter time

Move cursor to pos FF select cd

Load by pressing both buttons till display runs

Note. If framerate is selected in the FF pos then only the generator will be loaded.

2 . 4

Jamming the generator from external TC

The slate must be in the Generator or Generator/RTC mode.

Connect external TC.

Verify framerate and error with the blue button as in 2.2.2 and 2.2.3.

While holding down Blue button tip Red button ON shortly.

Red LED goes on then the Green LED blinks.

Check frame error with Blue button again.

The error bar should be on the far left.

Note1. The generator always runs with the framerate selected by the dipswitches.

Thus X jamming of framerates is possible. In other words a camera

runnning at 24 fps can jam a 30 fps slate.

Note2. The X jamming and the error check takes place at the 00 Frame transition.

Thus the error check works correctly between timecodes of different

framerates. A 24 fps timecode running with a 30 fps timecode will show no

error if the 00 frame points are coincident in time.

XX don't care