Ambient Recording ACD 201 Manual - Página 16
Navegue en línea o descargue pdf Manual para Equipos de grabación Ambient Recording ACD 201. Ambient Recording ACD 201 20 páginas.
Imprimir página
4.3.2 Receiver
The receiver is built into the slate and can be turned on and off with
the yellow switch under the slider to the right of the dip
switches. The switch removes the supply, and the timecode line from the
TC input when switched off. The reason for this is to remove receiver noise
from the input when the transmitter is not sending timecode.
Note: With the receiver on and the transmitter off there will be noise in the
timecode input line making the led glow red (see 2.1.3). In the
generator mode the radio receiver must be switched off to jam
the generator through the Lemo socket as the noise
otherwise corrupts the incoming timecode signal. Of course the
generator can be set from timecode received by the receiver but not the
socket and the receiver at the same time.
If the timecode transmitter is on but no timecode is being transmitted then
the noise output of the receiver will be much less. Always switch off
the receiver when not in use.
When receiving timecode from the radio link the slate generator also can
be jammed from this timecode or the slate can run in both reader and
reader/generator modes.
Note: Some Steadycam and camera focus remotes use the same
frequency as our timecode module, leading to poor reception and low
range
(interference).
4 . 4
Large Writing Sleeve
Due to users requests we offer a larger writing sleeve for the ACD master slate.
The width is a standard 11 inches „Fits in a front box" and the surface is covered
with a non reflective laser engraved label. Standard boxes are etched in the
surface.
N o t e : The writing surface is similar to Formica and can be dry wiped
clean. If the surface gets grey after frequent use it can be cleaned
occasionally with spirits or acetone.
N o t e : Too much cleaning with acetone or agressive solvents may
damage the writing surface!!
5
TECHNICAL DATA:
5.1
Mechanical Specification
Dimensions ACD 201
Weight
5.2
Electric specification
Current consumption
ACD 301
ACD 201
ACD 301
Display OFF
Display level 9
250 x 130 x 26 mm
250 x 160 x 26 mm
980 g with 6 batteries
1100 g with 9 batteries
30 mA
500 mA