ACR Electronics The Buxton BX1MF Manuel technique - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel technique pour {nom_de_la_catégorie} ACR Electronics The Buxton BX1MF. ACR Electronics The Buxton BX1MF 20 pages.

Imprimer la page

Instructions for use with wood

 Slide the top air control to the right and pull open the primary air fully.

 Lay firelighters or rolled up newspapers on the grate and add a small

amount of kindling wood to the top. Place 1 or 2 small logs on the top.

 Light the newspaper or firelighters using a long taper and push the

door to.

 When the fire is burning fiercely, after a couple of minutes add more

logs and close the door.

 When the fire has become established, close the primary air down.

 The burning rate can be altered by moving the top air slide.

 Care should be taken to ensure that the logs are not placed higher

than the log guard allows.

The air controls should not be adjusted except as directed in these

instructions

Instructions for use with smokeless fuel

 Slide the top air control to the right and open the primary air fully, fully

close the tertiary air tabs at the rear of the appliance.

 Lay firelighters or rolled up newspapers on the grate and add a small

amount of kindling wood to the top.

smokeless fuel on top.

 Light the newspaper or firelighters using a long taper and push the

door to.

 When the fire is burning fiercely, after a couple of minutes add more

smokeless fuel and close the door.

 When the fire has become established, close the top air down.

 The burning rate can be altered by moving the primary air slide.

 Care should be taken to ensure that the firebox is not overfilled with

smokeless fuel – it should be no higher than the log guard.

Re-fueling

When refueling the stove always refuel onto a bed of hot embers, fully

open the secondary air control and leave the door slightly ajar for a few

minutes or until the new fuel is well alight, before closing the door and

adjusting the air controls for the desired setting.

If there is insufficient burning material in the firebed to light a new fuel

charge, excessive smoke emission can occur. Refueling must be carried

out onto a sufficient quantity of glowing embers and ash that the new fuel

charge will ignite in a reasonable period. If there are too few embers in

the fire bed, add suitable kindling to prevent excessive smoke.

Place a small quantity of