amc VIBRO AVC 1000 Manuel de l'utilisateur - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} amc VIBRO AVC 1000. amc VIBRO AVC 1000 7 pages. Single channel conditioner icp/iepe
Imprimer la page
4.1. Installing / replacing batteries
In order to install or replace the batteries, remove the front panel of the casing after removing two
screws marked with the number 1 on Fig. 4.1, so that container for four AAA cells can be reached (Fig.
4.2). After putting new AAA cells into the container, insert it into the housing, and mount the front panel
back on its place with the screws.
The need to replace the cells is indicated by the 'Low Batt' LED.
Figure 4.1 View of the screws allowing access to
Figure 4.2 View of the removed battery container
the battery compartment.
WARNING!
Do not leave discharged batteries in the device, as it may cause a leak, resulting in damaging of
the conditioner.
WARNING!
If the conditioner is not used for a long time, remove the batteries to avoid leakage and damage.
4.2. Power supply
The unit can be powered with external power supply with 9V DC output voltage and minimal current
load of 100 mA. AC adapter is available as an option. It is recommended to use the AC transformer with
linear stabilization. Using a power supply with pulse stabilization can drastically increase the noise level
at the output of the conditioner.
WARNING!
Pay attention to the polarity of the adapter plug – it should be in line with the outlet polarity
marked on the top of the cabinet. Connecting the power supply incorrectly may damage the
conditioner.
5
AV CONDITIONER 1000 / ©AMC VIBRO Sp. z o.o.