amc VIBRO AVC 1000 User Manual - Page 5

Browse online or download pdf User Manual for Measuring Instruments amc VIBRO AVC 1000. amc VIBRO AVC 1000 7 pages. Single channel conditioner icp/iepe

Print Page

4.1. Installing / replacing batteries

In order to install or replace the batteries, remove the front panel of the casing after removing two

screws marked with the number 1 on Fig. 4.1, so that container for four AAA cells can be reached (Fig.

4.2). After putting new AAA cells into the container, insert it into the housing, and mount the front panel

back on its place with the screws.

The need to replace the cells is indicated by the 'Low Batt' LED.

Figure 4.1 View of the screws allowing access to

Figure 4.2 View of the removed battery container

the battery compartment.

WARNING!

Do not leave discharged batteries in the device, as it may cause a leak, resulting in damaging of

the conditioner.

WARNING!

If the conditioner is not used for a long time, remove the batteries to avoid leakage and damage.

4.2. Power supply

The unit can be powered with external power supply with 9V DC output voltage and minimal current

load of 100 mA. AC adapter is available as an option. It is recommended to use the AC transformer with

linear stabilization. Using a power supply with pulse stabilization can drastically increase the noise level

at the output of the conditioner.

WARNING!

Pay attention to the polarity of the adapter plug – it should be in line with the outlet polarity

marked on the top of the cabinet. Connecting the power supply incorrectly may damage the

conditioner.