Flomec QS200 Manuel du propriétaire du produit - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire du produit pour {nom_de_la_catégorie} Flomec QS200. Flomec QS200 16 pages. Insertion ultrasonic flowmeter options for large pipe sizes
Également pour Flomec QS200 : Manuel d'installation (8 pages), Manuel du propriétaire du produit (20 pages)
Imprimer la page
INSTALLATION ( CONTINUED )
Place the marked sleeve back into saddle, engaging the threaded studs to the depth
marked. Twist the bottom nuts upward to bottom of sleeve flange, replace the two nuts
removed earlier and tighten all nuts with 7/16 wrench. See Figure 5.
TIGHTEN DOWNWARD
TIGHTEN UPWARD
PERMANENT MARK
Figure 5
Step 4 – Mounting the Sensor:
Note the flow arrows on the side of the sensor, these must point downstream. Insert sensor
into sleeve, press down until hole in sensor matches hole in sleeve. Insert retention pin.
Final sensor depth should match that shown in Figure 6.
.060
.030
Figure 6
TIGHTEN DOWNWARD
TIGHTEN UPWARD
9