Amdi iAdapter-Mini 4 Mode d'emploi

Parcourez en ligne ou téléchargez le pdf Mode d'emploi pour {nom_de_la_catégorie} Amdi iAdapter-Mini 4. Amdi iAdapter-Mini 4 2 pages.

Installation and Operating Instructions for the iAdapter-Mini™ 2 & 4

Loosen the 8 (eight) screws from the back of the

iAdapter™ as shown in the picture below. These

screws are captive screws and will not fall out

after you loosen them and turn the bottom

housing over.

Place the iPad™ onto the 6 (six) rubber supports

inside the iAdapter™. The rubber supports are

color coded for the different iPad's. RED is for

iPad Mini versions 1 through 3. BLACK is for the

iPad Mini 4.

Make sure that the reset button of the iPad®

lines up with the reset button of the iAdapter™

as shown in the picture to the right.

Place the top housing of the iAdapter™ over the

iPad®. Align the top housing of the iAdapter™

with the bottom housing of the iAdapter™.

Carefully hold both the top and the bottom

housing of the iAdapter™ together and then turn

it over onto a flat surface. Tighten the 8 (eight)

screws that will hold the iAdapter™ together.