Amdi iAdapter-Mini 4 운영 지침

{카테고리_이름} Amdi iAdapter-Mini 4에 대한 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Amdi iAdapter-Mini 4 2 페이지.

Installation and Operating Instructions for the iAdapter-Mini™ 2 & 4

Loosen the 8 (eight) screws from the back of the

iAdapter™ as shown in the picture below. These

screws are captive screws and will not fall out

after you loosen them and turn the bottom

housing over.

Place the iPad™ onto the 6 (six) rubber supports

inside the iAdapter™. The rubber supports are

color coded for the different iPad's. RED is for

iPad Mini versions 1 through 3. BLACK is for the

iPad Mini 4.

Make sure that the reset button of the iPad®

lines up with the reset button of the iAdapter™

as shown in the picture to the right.

Place the top housing of the iAdapter™ over the

iPad®. Align the top housing of the iAdapter™

with the bottom housing of the iAdapter™.

Carefully hold both the top and the bottom

housing of the iAdapter™ together and then turn

it over onto a flat surface. Tighten the 8 (eight)

screws that will hold the iAdapter™ together.