10Bar Underwater Housing Manuel de l'utilisateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} 10Bar Underwater Housing. 10Bar Underwater Housing 15 pages. Underwater housing for olympus e-pl2
Également pour 10Bar Underwater Housing : Manuel de l'utilisateur (16 pages)

Imprimer la page

4. Set-up Instructions

Special Note on Responsibility for Watertight Integrity

Each housing is individually inspected and hydrostatically tested in the factory. However, the

responsibility for ensuring the integrity of the watertight seal lies entirely with the user. 10Bar accepts no

liability for damage to, or loss of any equipment used with, or placed inside the housing. It is highly

recommended that an in-water test of the housing without the camera be carried out before the first dive,

after changing ports or alteration of housing configuration. This simple test can be done by lowering the

housing with ballast to the expected diving depth and then retrieved to check for leaks.

Stainless Steel Locking Latch

•

The clear acrylic lid is secured to the housing by three Stainless Steel Locking Latches.

•

Locking Latches are simple, yet extremely secure mechanisms for locking down the housing lid.

Opening the Lid

Open the lid as illustrated below.

Latch in Locked Position

Align the Catch Under the Hook

Lift Tab at End of Lever Out and Up to Unlock

Lift Tab at End of Lever to Push the Hook and Lid Up