Aktakom AMM-1008 Manuel de l'utilisateur - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Aktakom AMM-1008. Aktakom AMM-1008 9 pages. 20 a digital multimeter
Imprimer la page
3. Touch the Temperature Probe head to the part whose temperature
you wish to measure. Keep the probe touching the part under test
until the reading stabilizes (about 30 seconds).
4. Read the temperature in the display. The digital reading will
indicate the proper decimal point and value.
WARNING: To avoid electric shock, be sure the thermocouple has
been removed before changing to another measurement function.
REPLACING THE BATTERY
WARNING: To avoid electric shock, disconnect the test leads from
any source of voltage before removing the battery door.
1.
When the batteries become exhausted or drop below the
operating voltage, "BAT" will appear in the right-hand side of the
LCD display. The battery should be replaced.
2.
Follow instructions for installing battery. See the Battery
Installation section of this manual.
3. Dispose of the old battery properly.
WARNING: To avoid electric shock, do not operate your meter
until the battery door is in place and fastened securely.
BATTERY INSTALLATION
WARNING: To avoid electric shock, disconnect the test leads from
any source of voltage before removing the battery door.
1.
Disconnect the test leads from the meter.
2.
Open the battery door by loosening the screw using a Phillips
head screwdriver.
3.
Insert the battery into battery holder, observing the correct
15
polarity.
4.
Put the battery door back in place. Secure with the one screw.
WARNING: To avoid electric shock, do not operate the meter
until the battery door is in place and fastened securely.
NOTE: If your meter does not work properly, check the fuses and
battery to make sure that they are still good and that they are
properly inserted.
REPLACING THE FUSES
WARNING: To avoid electric shock, disconnect the test leads from
any source of voltage before removing the
1. Disconnect the test leads from the meter and any item under test.
back cover
2. Open the
by loosening the screw on the
using a Phillips head screwdriver.
3. Remove the old fuse from its holder by gently pulling it out.
4. Install the new fuse into the holder.
5. Always use a fuse of the proper size and value (0.2A/250V fast
blow for the 200mA range, 20A/250V fast blow for the 10A range).
back cover
6. Put the
. Insert the screw and tighten it securely.
WARNING: To avoid electric shock, do not operate your meter until
the fuse door is in place and fastened securely.
back cover
back cover
16