Aktakom AMM-1008 사용자 설명서 - 페이지 8

{카테고리_이름} Aktakom AMM-1008에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aktakom AMM-1008 9 페이지. 20 a digital multimeter

페이지 인쇄

3. Touch the Temperature Probe head to the part whose temperature

you wish to measure. Keep the probe touching the part under test

until the reading stabilizes (about 30 seconds).

4. Read the temperature in the display. The digital reading will

indicate the proper decimal point and value.

WARNING: To avoid electric shock, be sure the thermocouple has

been removed before changing to another measurement function.

REPLACING THE BATTERY

WARNING: To avoid electric shock, disconnect the test leads from

any source of voltage before removing the battery door.

When the batteries become exhausted or drop below the

operating voltage, "BAT" will appear in the right-hand side of the

LCD display. The battery should be replaced.

Follow instructions for installing battery. See the Battery

Installation section of this manual.

3. Dispose of the old battery properly.

WARNING: To avoid electric shock, do not operate your meter

until the battery door is in place and fastened securely.

BATTERY INSTALLATION

WARNING: To avoid electric shock, disconnect the test leads from

any source of voltage before removing the battery door.

Disconnect the test leads from the meter.

Open the battery door by loosening the screw using a Phillips

head screwdriver.

Insert the battery into battery holder, observing the correct

polarity.

Put the battery door back in place. Secure with the one screw.

WARNING: To avoid electric shock, do not operate the meter

until the battery door is in place and fastened securely.

NOTE: If your meter does not work properly, check the fuses and

battery to make sure that they are still good and that they are

properly inserted.

REPLACING THE FUSES

WARNING: To avoid electric shock, disconnect the test leads from

any source of voltage before removing the

1. Disconnect the test leads from the meter and any item under test.

back cover

2. Open the

by loosening the screw on the

using a Phillips head screwdriver.

3. Remove the old fuse from its holder by gently pulling it out.

4. Install the new fuse into the holder.

5. Always use a fuse of the proper size and value (0.2A/250V fast

blow for the 200mA range, 20A/250V fast blow for the 10A range).

back cover

6. Put the

. Insert the screw and tighten it securely.

WARNING: To avoid electric shock, do not operate your meter until

the fuse door is in place and fastened securely.

back cover