Aerobics PaceMaster ProClub LT Manuel du propriétaire - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Aerobics PaceMaster ProClub LT. Aerobics PaceMaster ProClub LT 18 pages. Aerobics pacemaster proclub lt treadmill owner's manual
Imprimer la pageInstallation Requirements
Your ProClub LT should be installed indoors on a flat, level surface near a 120Volt/ 15Amp outlet. PaceMaster requires a dedicated, non-
switched outlet that is not part of a GFI (Ground Fault Interrupter) circuit, preferably no more than 5 feet from the outlet to eliminate the need
for an extension cord. You must have a minimum of 4 feet of clearance between the rear of the treadmill and any wall or obstruction.
TIP:
If you are installing your ProClub LT on a carpeted surface, use a treadmill mat or a scrap piece of carpet underneath the treadmill to
avoid soiling of the carpet. Deep pile carpet is not recommended.
Unpacking Your Treadmill
The PaceMaster treadmill is packed in five pieces:
•
Frame assembly
•
Front handlebar assembly with Control Panel
•
Two side rails
•
Motor cover
•
Hardware package
Before assembling your treadmill, open the hardware package and verify that you have the following items:
Two black side rail brackets
Two 1" fender washers
Four 1/4-20 x 3.5" black carriage bolt
Two 1/4-20 x 4" black carriage bolt
Six 1/4-20 kep nuts
If any parts are missing, contact the authorized PaceMaster retailer where you purchased your PaceMaster treadmill.
Tools Required for Assembly
•
3/16" Allen wrench (supplied)
•
7/16" combination wrench
•
Phillips head screwdriver
ASSEMBLY INSTRUCTIONS
Two #8 x ½" black sheet metal screws
3/16" Allen wrench
Magnetic safety key with garment clip
Owner's Manual
Warranty registration card
4