Aerobics PaceMaster ProClub LT Руководство пользователя - Страница 5
Просмотреть онлайн или скачать pdf Руководство пользователя для Беговая дорожка Aerobics PaceMaster ProClub LT. Aerobics PaceMaster ProClub LT 18 страниц. Aerobics pacemaster proclub lt treadmill owner's manual
Installation Requirements
Your ProClub LT should be installed indoors on a flat, level surface near a 120Volt/ 15Amp outlet. PaceMaster requires a dedicated, non-
switched outlet that is not part of a GFI (Ground Fault Interrupter) circuit, preferably no more than 5 feet from the outlet to eliminate the need
for an extension cord. You must have a minimum of 4 feet of clearance between the rear of the treadmill and any wall or obstruction.
TIP:
If you are installing your ProClub LT on a carpeted surface, use a treadmill mat or a scrap piece of carpet underneath the treadmill to
avoid soiling of the carpet. Deep pile carpet is not recommended.
Unpacking Your Treadmill
The PaceMaster treadmill is packed in five pieces:
•
Frame assembly
•
Front handlebar assembly with Control Panel
•
Two side rails
•
Motor cover
•
Hardware package
Before assembling your treadmill, open the hardware package and verify that you have the following items:
Two black side rail brackets
Two 1" fender washers
Four 1/4-20 x 3.5" black carriage bolt
Two 1/4-20 x 4" black carriage bolt
Six 1/4-20 kep nuts
If any parts are missing, contact the authorized PaceMaster retailer where you purchased your PaceMaster treadmill.
Tools Required for Assembly
•
3/16" Allen wrench (supplied)
•
7/16" combination wrench
•
Phillips head screwdriver
ASSEMBLY INSTRUCTIONS
Two #8 x ½" black sheet metal screws
3/16" Allen wrench
Magnetic safety key with garment clip
Owner's Manual
Warranty registration card
4