American Sportworks 3171 Manuel du propriétaire - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} American Sportworks 3171. American Sportworks 3171 12 pages. 136cc fun kart

Imprimer la page

maintenance

A. Front Wheel Replacement

Remove cotter pin and castle nut . Wheel should be easily removed . After replacing the wheels,

tighten castle nut and replace cotter pin with a new one . Replace rubber cover .

B. Rear Wheel Replacement

Remove cotter pin, castle nut, and washer . Wheel should be easily removed . After replacing the

wheels, replace the washer, tighten castle nut and replace cotter pin with a new one . Replace

rubber cover .

C. Front Wheel Alignment

The front wheels should be set with a "toe-in" from 1/4" to 1/2" . At the centerline of the tires,

measure the Distance A and the Distance B . For proper toe adjustment, Dimension A should be

1/4" – 1/2" greater than Dimension B . While adjusting, ensure rubber boots are in good condition .

To make adjustments:

1) Loosen the lock nuts on both sides of Front Tie Rods .

2) Ensure the steering wheel is centered, and adjust Dimension B by equally rotating the

tie rods in or out with a 12mm wrench .

3) After adjusting to the desired length, tighten the lock nuts against the Tie Rods .

4) Recheck the dimensions for proper alignment .

Left Rotate

Right Rotate

fig . 3 .3

CAUTION

Prevailing torque type locknuts must be replaced with new after the old locknuts are removed.

GENERAL MAINTENANCE

(see figure 3.1)

(see figure 3.2)

(see figures 3.3 & 3.4)

Toe Adjustment Diagram

(Model 5210 kart shown)

3171 OWNERS MANUAL

SECTION

Front Wheel

fig. 3.1

Rear Wheel

fig. 3.2

B + 1/4"

B + 1/2"

Lock Nuts

Right Rotate

Left Rotate

Castle nut

Cotter Pin

Rubber Cover

Washer

Castle Nut

Cotter Pin

Rubber Cover

fig. 3.4

Tie Rod

15023R1 rev. A

pub. 05/19/2015