American Sportworks 3171 Manual do Proprietário - Página 9

Procurar online ou descarregar pdf Manual do Proprietário para Veículo utilitário American Sportworks 3171. American Sportworks 3171 12 páginas. 136cc fun kart

Imprimir página

maintenance

A. Front Wheel Replacement

Remove cotter pin and castle nut . Wheel should be easily removed . After replacing the wheels,

tighten castle nut and replace cotter pin with a new one . Replace rubber cover .

B. Rear Wheel Replacement

Remove cotter pin, castle nut, and washer . Wheel should be easily removed . After replacing the

wheels, replace the washer, tighten castle nut and replace cotter pin with a new one . Replace

rubber cover .

C. Front Wheel Alignment

The front wheels should be set with a "toe-in" from 1/4" to 1/2" . At the centerline of the tires,

measure the Distance A and the Distance B . For proper toe adjustment, Dimension A should be

1/4" – 1/2" greater than Dimension B . While adjusting, ensure rubber boots are in good condition .

To make adjustments:

1) Loosen the lock nuts on both sides of Front Tie Rods .

2) Ensure the steering wheel is centered, and adjust Dimension B by equally rotating the

tie rods in or out with a 12mm wrench .

3) After adjusting to the desired length, tighten the lock nuts against the Tie Rods .

4) Recheck the dimensions for proper alignment .

Left Rotate

Right Rotate

fig . 3 .3

CAUTION

Prevailing torque type locknuts must be replaced with new after the old locknuts are removed.

GENERAL MAINTENANCE

(see figure 3.1)

(see figure 3.2)

(see figures 3.3 & 3.4)

Toe Adjustment Diagram

(Model 5210 kart shown)

3171 OWNERS MANUAL

SECTION

Front Wheel

fig. 3.1

Rear Wheel

fig. 3.2

B + 1/4"

B + 1/2"

Lock Nuts

Right Rotate

Left Rotate

Castle nut

Cotter Pin

Rubber Cover

Washer

Castle Nut

Cotter Pin

Rubber Cover

fig. 3.4

Tie Rod

15023R1 rev. A

pub. 05/19/2015