Domus CHAM-TOUCH-3C Instructions d'utilisation - Page 3
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation pour {nom_de_la_catégorie} Domus CHAM-TOUCH-3C. Domus CHAM-TOUCH-3C 3 pages. 3ch wall controller
Imprimer la page
Operation
1. Do wiring the wall panel & RF+Bluetooth receiver according to wiring diagram
(please refer to the instruction of RF+Bluetooth receiver that you would like to pair with).
2. Power on, then touch the button
Pair with RF+Bluetooth receiver
Built-in 10 colour changing modes are as follows:
Mode 1:
Any two colours of RGB mix fade-in & fade-out
Mode 2:
RGB three colours mix fade-in & fade-out
Mode 3:
RGB three colours mix fade-out & fade-in
Mode 4:
RGB flash
Mode 5:
RGB three colours fade-in & fade-out successively
Mode 6:
RGB three colours fade-in successively
Mode 7:
RGB three colours fade-out successively
Mode 8:
RGB three colours jump changing successively
Mode 9:
R&B two colours mix fade (R in B out), then G fade-in, then R&B mix fade (R out B in), then G fade-out
Mode 10: B fade-out, then G&B mix fade (G out B in), then R&G mix fade (R out G in), then R fade-in
Note:
-The lamp must be installed by professional electrician
-Ensure the power supply is switched off before fitting this product
[email protected] | www.domuslighting.com.au
to turn on the controller, indicator of the controller turned blue.
Prog
Step 1: Click the "Prog. Key" on RF+Bluetooth receiver (or reset power of the
receiver 3 times continuously if the button is not accessible) to set it into pairing
to RF+Bluetooth remote status.
Step 2: Touch the colour wheel, LED lights connected with the RF+Bluetooth
receiver flicker once means the receiver is paired with the wall panel
successfully.
29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia
Phone: 02 9554 9600 | Fax: 02 9554 9433
RF+Bluetooth LED Receiver
-Do not touch the lamp when in use
-Keep away from hot steam and corrosive gas
Installation Manual