- ページ 3

コントローラー Domus CHAM-TOUCH-3CのPDF 操作説明をオンラインで閲覧またはダウンロードできます。Domus CHAM-TOUCH-3C 3 ページ。 3ch wall controller

Operation

1. Do wiring the wall panel & RF+Bluetooth receiver according to wiring diagram

(please refer to the instruction of RF+Bluetooth receiver that you would like to pair with).

2. Power on, then touch the button

Pair with RF+Bluetooth receiver

Built-in 10 colour changing modes are as follows:

Mode 1:

Any two colours of RGB mix fade-in & fade-out

Mode 2:

RGB three colours mix fade-in & fade-out

Mode 3:

RGB three colours mix fade-out & fade-in

Mode 4:

RGB flash

Mode 5:

RGB three colours fade-in & fade-out successively

Mode 6:

RGB three colours fade-in successively

Mode 7:

RGB three colours fade-out successively

Mode 8:

RGB three colours jump changing successively

Mode 9:

R&B two colours mix fade (R in B out), then G fade-in, then R&B mix fade (R out B in), then G fade-out

Mode 10: B fade-out, then G&B mix fade (G out B in), then R&G mix fade (R out G in), then R fade-in

Note:

-The lamp must be installed by professional electrician

-Ensure the power supply is switched off before fitting this product

[email protected] | www.domuslighting.com.au

to turn on the controller, indicator of the controller turned blue.

Prog

Step 1: Click the "Prog. Key" on RF+Bluetooth receiver (or reset power of the

receiver 3 times continuously if the button is not accessible) to set it into pairing

to RF+Bluetooth remote status.

Step 2: Touch the colour wheel, LED lights connected with the RF+Bluetooth

receiver flicker once means the receiver is paired with the wall panel

successfully.

29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia

Phone: 02 9554 9600 | Fax: 02 9554 9433

RF+Bluetooth LED Receiver

-Do not touch the lamp when in use

-Keep away from hot steam and corrosive gas

Installation Manual