Da-Lite ADVANTAGE DELUXE ELECTROL Manuel d'instruction - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Da-Lite ADVANTAGE DELUXE ELECTROL. Da-Lite ADVANTAGE DELUXE ELECTROL 12 pages. Automatic electric projection screen
Également pour Da-Lite ADVANTAGE DELUXE ELECTROL : Spécifications (2 pages), Manuel d'instruction (12 pages), Données de spécification (2 pages), Manuel d'instruction (12 pages), Manuel d'instruction (9 pages), Manuel d'instruction (8 pages)

Imprimer la page
Da-Lite ADVANTAGE DELUXE ELECTROL Manuel d'instruction

Screen Adjustment

NOTE: Use a screw driver or 5/32" Allen wrench to make adjustments.
More Screen Drop
1. Place operating switch in "down" position.
2. When the screen stops, turn the white "down" limit knob (Fig.
2) one-quarter turn counterclockwise. Test by raising picture
surface approximately two feet, then lower again. Repeat until
desired picture surface position is attained.
CAUTION: Do not adjust for more drop than what was
ordered. At least 1-1/2 wraps of fabric must remain on the
roller. This screen comes standard with 0" or 2" black at
the top. See the specification data sheet for details.
ATTENTION! N'effectuez pas de réglage pour obtenir un
déroulement supérieur à celui commandé. Au moins 1 à 1/2
tour de toile doit être maintenu sur le cylindre. Cet écran est
doté de série d'une bande noire supérieure de 0 cm (0 po) ou
5 cm (2 po). Consultez la fiche technique pour plus de
renseignements.
4
Less Screen Drop
1. Raise picture surface approximately two feet above
desired level.
2. Place operating switch in "off"position.
3. Turn the white "down" limit switch (Fig. 2) one-quarter turn
clockwise. Test by raising picture surface approximately two
feet, then lower again. Repeat until desired picture surface
position is attained.
Contact Da-Lite at 800-622-3737 if door motor needs
adjustment.