Dontek PWP2 Ioniser Manuel d'instruction - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Dontek PWP2 Ioniser. Dontek PWP2 Ioniser 7 pages.

Imprimer la page

AUTO IONS REDUCE

YES/NO

This feature automatically adjusts the

IONS OUTPUT to a lower value after 30

days, if NO is selected you will return to

5)SYSTEM SETUP, if YES is selected

then you are prompted for the fall back

current;

IONS FALLBACK

SET FOR xxx mA

6) SAVE & EXIT

When this menu is selected, push Enter to

save ALL settings, the unit will return to

normal operation automatically. If any of

the menu items are left unattended for 3

minutes the menu will time out and

automatically save all settings and return

to automatic operation.

THE ENTER/MANUAL BUTTON

If at any time the ENTER/MANUAL button

is pressed the pump is switched on and

the following will be displayed;

ON/OFF ↑ ↓

ENTER = AUTO

This function is used for system back

wash, pool vacuuming, spa heating, etc.

The filter pump is allowed to run but the

Ions Output is turned to OFF. Use the

Up/Down buttons to turn the pump

ON/OFF, after four hours the system will

automatically return to normal automatic

run mode.

PWP2_Instructions_rA1.docx

SPECIAL TEST MENU

This menu is for special access and

should normally not be required.

To enter test mode, press and hold the

Enter button while the power to the unit is

turned on, after 2 seconds release the

Enter button.

OUTPUT CURRENT:

NORMAL (DEFAULT)/HIGH

When output current is set to high it

enables higher values to be set under the

'3) IONS OUTPUT' menu, when set to

normal the maximum value is 250mA but

when set to high it can be set as high as

400mA.

If you select NORMAL (DEFAULT) it will

also enter the production test and will

perform a short output current test then

resetting itself and returning to normal

operation.

Normal Operation for factory default

settings: Between 09:00 and 13:00 or

16:00 and 20:00 the PUMP will be on, as

well as IONS ACTIVE & PUMP ON LEDs,

ionising current is set for 200mA. When

minutes of the day is between; 0-14 then

TOP POLARITY LED is ON, 15-29 then

BOTTOM POLARITY LED is ON, 30-44 then

TOP POLARITY LED is ON, 45-59 then

BOTTOM POLARITY LED is ON. At other

times ALL LED's should be OFF.