astra telematics AT210 Manuel de démarrage rapide - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} astra telematics AT210. astra telematics AT210 4 pages. Vehicle tracking device
Également pour astra telematics AT210 : Manuel de l'utilisateur (9 pages), Manuel d'installation (5 pages)
Imprimer la page
5. Slide the AT210 assembly into the enclosure
a. Note that the GNSS antenna faces the top of the enclosure (with the slots)
b. Ensure that the PCB is aligned with the guide slots inside the enclosure and carefully
push in until the clips snap together
Fit the CB211 cable to the AT210 system connector
6.
a. The CB211 cable has a DB9 female RS232 connector and 4 way Molex Microfit
connector for power and ignition.
b. Connect the DB9 serial connector to your PC COM port or USB-RS232 adapter
c. If you have fitted a battery you should now see text scrolling continuously from the
AT210 to TeraTerm
d. Connect the power as outlined below
CB211 cable
CB001 cable (3 way power & ign)
e. Connect the IGNITION wire to an ignition switched 12/24V signal (i.e. something that
only goes live when the vehicle ignition is ON
+VE Power
-VE Power
red
black
red
black
IGNITION
white
white