DoorHan SLIDING-2100 Manuel d'installation et d'utilisation - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} DoorHan SLIDING-2100. DoorHan SLIDING-2100 16 pages. Drive
Également pour DoorHan SLIDING-2100 : Manuel d'installation et d'utilisation (12 pages), Manuel d'installation et d'utilisation (12 pages)
Imprimer la page
8.
MAIntenAnCe
AttentIon! After you install the operator, remove the breather screw.
Make sure that the door works normally and is well-balanced. Check operable condition of the units of the system and safety
devices. Have the qualified technicians service the operator. Keep the operator clean.
•
The manufacturer reserves the right to make changes and alterations in the product design without preliminary notice.
•
The manual describes the procedures for installation and adjustment of the SLIDING-1300/2100 operator.
•
Following the operation and maintenance recommendations for the operator as well as installation procedures for the
operator and the door described in the Manual will guaranty long life of the equipment and reduce risk of accidents when
installing and operating the door.
•
Do observe safety standards at installation, operation and maintenance.
•
If you need a copy of this Manual, contact the DoorHan company: 120, Novaya Street, Akulovo, Odintsovo District,
Moscow Region, Russia, 143002; or [email protected].
•
The manufacturer (DoorHan) does not handle installation, operation, maintenance of doors and automatics and is not
responsible for installation, operation and maintenance safety.
•
The contents of this Manual shall not be basis for any claim.
9.
tRoUBLesHootInG
symptom
Operator does not run.
After use of release the door does
not move.
Operator stops suddenly.
Gate does not open/close in full.
12
Possible reason
power to the operator is turned off or cut.
There is an obstacle to door movement.
Bad connection of electric wires.
The operator is released.
The door is not balanced.
Operator's thermal protection activates.
Incorrect adjustment of limit switches or run time.
Incorrect adjustment of limit switches.
Force protection activates.
solution
Check that power to the operator is on.
Remove the obstacle.
Check wiring.
Engage the operator.
Adjust the door.
Let the operator cool.
Adjust position of limit switches and run time.
Adjust end switches.
Adjust operator's force.
MaIntenance