Astria Fireplaces ORION32ZB6 Manuel d'installation et d'utilisation - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Astria Fireplaces ORION32ZB6. Astria Fireplaces ORION32ZB6 20 pages. Universal vent-free firebox
Imprimer la page
Firebox
floor
Loose knot in power
cord to take up slack
Figure 19
Cabinet Base
Figure 20
Bend Locating Tabs Over
Figure 21
Step 6. Route a 3-wire, 120 VAC, 60 Hz, 1 ph power supply to the right
side of appliance.
Step 7. Locate the J-Box cover (provided in J-Box Kit). Remove the round
knock-out (see Figure 16).
14
Locating Tabs
(into notches)
NOTE: DIAGRAMS & ILLUSTRATION ARE NOT TO SCALE.
Step 8. Ensure that power supply wires are NOT "live" before making
these connections). Install J-Box Cover Plate as follows:
Feed the * Romex wires (or other equivalent plastic insulated
wire - Refer ANSI/NFPA 70 - National Electrical Code - Latest
Edition) through the J-Box Cover rectangular opening, then con-
nect to the J-box wires. The strain relief bushing (not supplied)
should be pressed into the knock-out on J-box cover around the
Romex (this will provide protection to the wires and prevents strain
against connections from J-box). See Wiring Diagram - Figure
14. Install the cover plate over J-Box opening on appliance as
shown in Figure 22.
NOTE: Wire connections should be positioned inside of the ap-
pliance.
* Romex is a plastic insulated wire from power supply - sometimes called
non-metallic sheath.
Right Side Panel of Firebox
Use screw provided and
secure in place as shown
Screw
Figure 22 -
Installing J-box Cover Plate - All Models
Step 9. Follow the instructions below for the kit you are installing:
FBK-100 Kits - Install a locally sourced ON/OFF wall switch in
a convenient location on a wall, near the fireplace.
FBK-200 Kits - Install the kit-provided variable speed control
(rheostat) in a convenient location on a wall, near the fireplace.
Step 10. Follow the instructions below for the model you are installing:
Reinstall the blower access panel that was removed on Step 1 (see
Figure 15).
J-Box opening
on appliance
The notched side of
cover plates goes inside
firebox panel
Cover Plate