ASTRO DEVICES Nexus DSC Pro Manuel d'installation rapide - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} ASTRO DEVICES Nexus DSC Pro. ASTRO DEVICES Nexus DSC Pro 13 pages.
Imprimer la page
The telescope does not have to be
positioned exactly at the angle specified,
but it should be within ±10°. You can also set
the altitude reference to any angle between
-180° and +180° by selecting
from the list and by adjusting the angle:
Please note that the altitude reference angle is
individual for each telescope configuration –
this angle will be stored in the settings for the
currently selected telescope.
Nexus DSC Pro will automatically switch the
screen to the selection of first alignment object:
While Nexus DSC Pro can be aligned on any
object in its database it is best to use objects
form either Named Stars catalogue or Bright
Stars catalogue. You can press
the CATALOGUE tab and selecting a different
catalogue then press the
the object selection.
It is time to select the first alignment object – by
pressing
and
star:
Gacrux was selected as it is well above 30
degrees. Now the telescope should be pointed
at
Gacrux
using
reticle/crosshair or a very high magnification
7
Custom
to go to
key to return to
to change to another
an
eyepiece
with
eyepiece. Press the
telescope is pointing at the star.
Nexus DSC Pro will now switch to the selection
of a second alignment object:
Please follow the procedure described above to
change the selection of the second alignment
object if necessary.
Press the
OK
centre of the eyepiece.
Now Nexus DSC Pro will show the alignment
status – Successful or Failed:
Now you can press either the
key to go to the previous menu.
ESC
You can go back to align on first or to align
on second object at any time in case the
alignment error is too big.
Two star alignment using SkySafari
Plus/Pro
Please refer to the SkySafari Setup section in
this guide to start using Nexus DSC Pro with
SkySafari.
Perform the Altitude reference alignment first –
as described above.
Touch the Connect button on the telescope
control panel in SkySafari.
SkySafari will show where the telescope is
pointing but the position will most likely be
incorrect as the two star alignment has not yet
been performed.
In this example the altitude reference was 90º:
a
Nexus DSC Pro Quick Setup Guide
button once the
OK
button once the star is in the
button or the
OK