AstroJet AJ-140 Manuel de démarrage rapide - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} AstroJet AJ-140. AstroJet AJ-140 4 pages.
Imprimer la page
Step 3
Connect Power to Printer
1. Main Power Switch [1] is
turned OFF.
2. Check that the Printer is
set for the power to be
used (115V or 220V) [A].
3. Connect one end of
power cord to rear
receptacle on Printer.
4. Plug other end into a 115-
220 Volt AC (depending
on Printer voltage), 50/60 Hz. grounded outlet.
NOTE: START ONE PRINTER AT A TIME WHEN
SIMILAR PRINTERS ARE ON THE SAME NETWORK.
Connect Printer to Computer
USB 3.1 Port: Plug
USB cable into
connector [1]. Cable
used to connect
Printer to computer
must not exceed 6
feet long.
Ethernet (Network)
Port: Plug network
Ethernet cable into
connector [2].
Wi-Fi Port: Connect Wi-Fi antenna (included) to this
port [3] for wireless Printer monitoring or operation
through your network.
DO NOT CONNECT USB CABLE
OR NETWORK CABLE YET.
DO NOT TURN PRINTER POWER
SWITCH [1] ON YET.
Step 4
Install Inkjet Cartridges
The AJ-140 holds 4 Inkjet Cartridges.
1. Remove inkjet
cartridge from
packaging.
DO NOT touch
copper contacts,
metal plate, or gold
printhead. Remove
protective tape from
Printhead.
2. [A] With
Cartridge's
Printhead pointing
down and while
keeping the
Cartridge lightly in
contact with the
edge of the Latch
Lever: Slide the
Cartridge into
Holder at as vertical
an angle as
possible.
[B] Push straight
back toward
contacts in the
Printhead Holder.
NOTE: Be careful
not to bend the
contact pins in the
Holder or to
damage the
surface of the
Cartridge
Printhead.
[C] Make sure
Cartridge is seated
in Holder.
3. Close Latch Lever
to secure Cartridge in Holder.
DO NOT force Lever into place.
4. Repeat Steps 1-3 for remaining Inkjet Cartridges.
Page 2
Ink in Cartridge may be harmful if
swallowed. Keep new and used
Cartridges out of reach of
children. Discard empty
Cartridges immediately.