AstroJet AJ-140 Manuel de démarrage rapide - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} AstroJet AJ-140. AstroJet AJ-140 4 pages.

Step 5

Setting Up Feed

Printer has four Sheet Separators, two Side Guides, and

a Rear Media Support and Guide.

Adjust Sheet Separators individually:

1. Release Separator Locking Levers (located on

operator's side of Feeder), raise Separators and

lock in position. Move Side Guides to outermost

open position. Place one piece of media in

center of Feed Table.

2. Four Separators on Feeder. Use two Center

Separators for narrow media and all four

Separators for wide media. Place media under

Separators and lower Separators onto media.

3. Rotate Locking Lever up to lock Separators

in place.

4. Loosen knobs on Side Guides. Adjust Side

Guides to within 1/32" of media. Tighten knobs.

5. Adjust Rear Guide so media is raised

approximately 1/2" and rests on curve of Rear

Guide. When running 10" or longer or heavy

media Rear Guide may have to be set so it just

touches back of media.

6. Positioning Cartridge Printheads: Adjust

positioning of Printhead Cartridge Assembly by

loosening locking screw [D]. Slide Assembly as

needed to print on media being used.

7. Turn Printer ON. Turn Media Thickness Knob

[A] fully counterclockwise to raise the Printhead

to its highest position.

Place a piece of media [B] under the Printhead

Carriage. Adjust the Media Thickness Knob

clockwise until the Printhead Carriage just

touches the media.

Turn Media Thickness Knob counterclockwise

until media [

Carriage with a slight pull.

NOTE: These are initial settings.

It may be necessary to adjust the Media

Thickness Control to optimize print quality.

8. Test feed media by pressing "Test Feed" on the

Quick Menu Touchscreen.

Page 3

B] can be pulled from under Print