Dahua F Series Manuel de démarrage rapide - Page 16

Dahua HD Pinhole Network Camera Quick Start Guide

3 Network Configuration

The IP address of all the cameras is the same when leaving factory (default IP 192.168.1.108).

To make the camera access to the network smoothly, please plan the available IP segment

reasonably according to the actual network environment.

The cameras which are accessed via wired network can acquire and modify the IP address

through "Quick Configuration Tool". For the wireless network cameras, you need to connect to

the wired network to configure wireless parameters before use.

This section introduces the approach of modifying IP address via "Quick Configuration Tool". You

can also modify the IP address in the network parameters of the WEB interface. Please refer to

the document WEB Operation Manual in the disk for more details.

Note

The camera can be configured only when the IP addresses of the camera and the computer are

in the same network segment.

To modify IP address, do the following:

1. Double-click the "ConfigTools.exe" and open the "Quick Configuration Tool".

2. Double-click the device that needs to be configured.

The system will pop out the Login dialog box. See Figure 3-1 for more details.

3. Enter the IP address, username, password and port number of the camera, and then click

OK.

Note

The default username and password is admin and admin respectively, and the default port

is 37777.

Figure 3-1 Login