Electric Co WDH-610HA Manuel - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Electric Co WDH-610HA. Electric Co WDH-610HA 19 pages.

Imprimer la page

Problem

The fan and the

compressor are not

working

Not collecting

water

Noise emission

during usage

Frozen condenser

Water leakage

CLEANING

Air Filter

- The air filter must be regularly cleaned. This filter is behind the air inlet grid (B).

Note: for a daily use, the filter should be cleaned once a week.

- To remove the filter, remove the tank (A) and tip the appliance towards the rear at an

angle of approximately 15º. Hold the filter and pullet downwards (Fig. 4).

- Clean the air filter with water and place is back on the appliance.

Note: it is not necessary for the filter to be completely dry when you replace it in the

appliance.

Possible Cause

The appliance has no power

Motor failure

Electronic fault

Air inlet filter blocked

Low level of refrigerant gas

Temperature and humidity are

too low

The surface where the

appliance is placed is irregular

Dirty air filter

Temperature is too low

Drainage tank (A) is not fitted

correctly

Micro switch failure

Frozen appliance

Solution / Hint

Check that if the appliance's

plug is properly connected to

a wall socket.

Check if the wall socket is

damaged.

Go to the store where the

appliance was bought.

Go to the store where the

appliance was bought.

Clean the air filter.

Go to the store where the

appliance was bought.

Turn off the appliance and

wait for the temperature to

rise.

Place the appliance on a flat

a stable surface.

Clean the air filter.

Turn off the appliance and

wait for the temperature to

rise.

Fit the drainage tank (A)

properly.

Go to the store where the

appliance was bought.

Turn off the appliance and

wait until the ice defrosts.