Douglas Dynamics 77700 Manuel d'instructions d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Douglas Dynamics 77700. Douglas Dynamics 77700 14 pages. Light truck snowplow

Imprimer la page

4. Move the snowplow into an upright operating

position.

5. Reinstall the trip springs.

6. Adjust the trip springs by tightening the top nuts

until the coils of the springs begin to separate

(a piece of paper, such as this instruction sheet,

should pass between the second and third coils).

Remove the protective packaging from the angle

rams.

8. Align the holes in the rod end of the angle ram

with the corresponding holes on the back of the

quadrant.

9. Install a 1/2" x 3‑11/16" clevis pin from the top

down to attach each rod. Secure the clevis pins

with 5/32" x 1‑1/2" cotter pins from the parts bag.

Lit. No. 52524, Rev. 05

INSTALLATION INSTRUCTIONS

FINAL BLADE ASSEMBLY

1. Install a blade guide on each end of the blade as

shown.

5/16" x 1" Cap Screws

2. Install the supplied 1/2" x 1‑3/4" carriage bolts

and 1/2" locknuts in the two cutting edge holes

previously used for securing the blade to the

pallet.

Blade Guide

5/16" Locknuts

July 15, 2020