Douglas Dynamics 77700 Інструкція з монтажу Посібник з монтажу - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Автомобільні аксесуари Douglas Dynamics 77700. Douglas Dynamics 77700 14 сторінок. Light truck snowplow
Друкувати сторінку4. Move the snowplow into an upright operating
position.
5. Reinstall the trip springs.
6. Adjust the trip springs by tightening the top nuts
until the coils of the springs begin to separate
(a piece of paper, such as this instruction sheet,
should pass between the second and third coils).
7.
Remove the protective packaging from the angle
rams.
8. Align the holes in the rod end of the angle ram
with the corresponding holes on the back of the
quadrant.
9. Install a 1/2" x 3‑11/16" clevis pin from the top
down to attach each rod. Secure the clevis pins
with 5/32" x 1‑1/2" cotter pins from the parts bag.
Lit. No. 52524, Rev. 05
INSTALLATION INSTRUCTIONS
FINAL BLADE ASSEMBLY
1. Install a blade guide on each end of the blade as
shown.
5/16" x 1" Cap Screws
2. Install the supplied 1/2" x 1‑3/4" carriage bolts
and 1/2" locknuts in the two cutting edge holes
previously used for securing the blade to the
pallet.
7
Blade Guide
5/16" Locknuts
July 15, 2020