Douglas Dynamics 77705 Manuel d'instructions d'installation - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Douglas Dynamics 77705. Douglas Dynamics 77705 14 pages. Light truck snowplow
Imprimer la pageUNPACKING
1. Set aside the blade guides and parts bags. The
vehicle electrical harnesses and Owner's Manual
packet are in the bag with the headlamp box.
Remove the receivers by moving the handle back
toward the receivers, disengaging the hitch pins.
Remove receivers and set aside.
2. Remove the lag screws and wood blocks. Remove
the cable ties securing the headlamp channel
to the headgear and set the headlamp channel
aside.
3. Remove the fasteners and blocking securing the
A‑frame to the pallet.
Handle
Lit. No. 52524, Rev. 05
INSTALLATION INSTRUCTIONS
Trip Bumper
1/2" x 3-11/16"
Clevis Pin
Pivot
Tube
Quadrant
A-Frame
5/32" x 1-1/2"
Cotter Pin
Trip Bumper
5/16" Flat Washer
5/16" Locknut
A‑FRAME TO BLADE ASSEMBLY
1. Loosen and remove both trip springs and tip the
blade forward. Insert the nose of the A‑frame into
the quadrant and align the pivot bolt hole on the
A-frame with the pivot bolt tube on the quadrant.
Insert the pivot tube through the quadrant into the
A-frame, tapered end first.
2. Install a trip bumper to each end of the pivot tube
and under the blade stop as shown below. The
round boss on the bumper will fit into the pivot
tube, and the bumpers will butt up against the
upper and lower edges of the quadrant.
3. Install the trip bumpers using 5/16" x 5" cap
screws, 5/16" flat washers, and 5/16" locknuts,
as shown below. Tighten the fasteners until the
bumpers begin to dimple.
5/16" x 5"
Cap Screw
5/32" x 1-1/2"
Cotter Pin
6
5/16" Washer
1/2" x 3-11/16"
Clevis Pin
July 15, 2020