Douglas Dynamics Fisher Minute Mount 2 XLS 50810 Manuel d'instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Douglas Dynamics Fisher Minute Mount 2 XLS 50810. Douglas Dynamics Fisher Minute Mount 2 XLS 50810 17 pages. Snowplow

Imprimer la page

50600, 50810

SAFETY DEFINITIONS

WARNING

Indicates a potentially hazardous situation

that, if not avoided, could result in death or

serious personal injury.

CAUTION

Indicates a potentially hazardous situation

that, if not avoided, may result in minor or

moderate injury. It may also be used to alert

against unsafe practices.

NOTE: Indicates a situation or action that can lead

to damage to your snowplow and vehicle or other

property. Other useful information can also be

described.

Instruction Label

Headgear

Jack

(fully raised)

Headlamp

Bracket

Pin Release

Handle (raised)

Stop

Jack

Lock

Handle

Pin Release

Attachment

Handle

Arm

(lowered)

Connecting

Jack

(lowered)

U.S Patents 4,999,935; 5,353,530; 5,420,480; 6,253,470; 6,944,978; RE 35,700;

CAN Patent 2,060,425; and other patents pending.

Read Owner's Manual For Complete Instructions

1. Place control in Lower/Float to put blade

down.

2. Pull and hold Jack Lock out. Jack will drop to

ground. Then pull Pin Release Handle away

from Stop and Jack Lock. Release Jack

Lock. Verify Jack is locked by trying to lift

Jack.

Lit. No. 50579, Rev. 02

1. Push

Pin Release

Handle down to pull out

Connecting Pins.

2. Drive vehicle slowly to engage

Pushplates into Attachment Arms.

3. Stand in front of blade. Fully raise Pin Release

Handle to release Connecting Pins.

4. Push Headgear toward vehicle to allow Connecting Pins

Pushplate

to fully engage Pushplates. If unable to push Headgear

from in front of blade, stand in front of Headgear on driver

side and push Headlamp Bracket.

5. Pull out Jack Lock. Push Pin Release Handle into Stop.

6. While holding Jack Lock out, use Jack Handle to raise

Jack fully. Release Jack Lock.

7. Attach all electrical connectors.

3. Stand in front of blade. While pushing Headgear toward

vehicle with left hand, push Pin Release Handle down to

disengage Connecting Pins. Make sure Connecting

Pins are fully retracted. If unable to push Headgear from

in front of blade, stand in front of Headgear on driver side

and push Headlamp Bracket.

4. Detach all electrical connectors.

WARNING/CAUTION AND INSTRUCTION

LABELS

Become familiar with and inform users about the

warning labels on the back of the blade and the

instruction label on the headgear.

NOTE: If labels are missing or cannot be read, see

your sales outlet.

Warning/Caution Label

LOWER BLADE WHEN VEHICLE IS PARKED.

DO NOT EXCEED GVWR OR GAWR INCLUDING BLADE

AND BALLAST.

REMOVE BLADE ASSEMBLY BEFORE PLACING

VEHICLE ON HOIST.

READ OWNER'S MANUAL BEFORE OPERATING OR

SERVICING SNOWPLOW.

TRANSPORT SPEED SHOULD NOT EXCEED 45 MPH.

FURTHER REDUCE SPEED UNDER ADVERSE TRAVEL

CONDITIONS.

PLOWING SPEED SHOULD NOT EXCEED 10 MPH.

SEE YOUR SALES OUTLET/WEB SITE FOR SPECIFIC

VEHICLE APPLICATION RECOMMENDATIONS.

27451

WARNING

CAUTION

59900

Multiple Pinch Points Label

XLS™ Blades Only

(both sides)

April 15, 2010