Douglas Dynamics SnowEx Automatixx SPEEDWING 77740 Manuel d'instructions d'installation - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Douglas Dynamics SnowEx Automatixx SPEEDWING 77740. Douglas Dynamics SnowEx Automatixx SPEEDWING 77740 17 pages.
Imprimer la page
7.
Insert the threaded end of the cable through the
driver-side pivot bushing from the center out.
Slide the cable through the spring until the eyelet
hole lines up with the driver-side mounting clevis
on the A-frame. Insert the eyelet into the clevis
and secure with a 5/8" x 2-5/16" clevis pin and
1/4" x 1-1/2" cotter pin. Repeat on passenger's side.
5/8" x 2-5/16"
Clevis Pin
8. Assemble a 3/4" hex nut and 3/4" jam nut loosely
onto the threaded end of the driver-side cable.
3/4" Jam Nut
Thread the nuts on just fl ush with the end of the
cable. Repeat on the passenger's side.
NOTE: Final adjustment of the cables will
take place in the Operational Test and Final
Adjustments section of this document.
Lit. No. 52308, Rev. 06
INSTALLATION INSTRUCTIONS
1/4" x 1-1/2"
Cotter Pin
Cable
3/4" Hex Nut
9. Stand the blade and A-frame assembly upright and
support it in a level position using a block under the
main A-frame tube. Install the blade guides using
5/16" x 1" cap screws and 5/16" locknuts.
Blade
Guide
5/16" x 1"
Cap Screws
8
5/16"
Locknuts
May 1, 2021