Douglas Dynamics SnowEx Automatixx SPEEDWING 77740 설치 지침 매뉴얼 - 페이지 8
{카테고리_이름} Douglas Dynamics SnowEx Automatixx SPEEDWING 77740에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Douglas Dynamics SnowEx Automatixx SPEEDWING 77740 17 페이지.
페이지 인쇄
7.
Insert the threaded end of the cable through the
driver-side pivot bushing from the center out.
Slide the cable through the spring until the eyelet
hole lines up with the driver-side mounting clevis
on the A-frame. Insert the eyelet into the clevis
and secure with a 5/8" x 2-5/16" clevis pin and
1/4" x 1-1/2" cotter pin. Repeat on passenger's side.
5/8" x 2-5/16"
Clevis Pin
8. Assemble a 3/4" hex nut and 3/4" jam nut loosely
onto the threaded end of the driver-side cable.
3/4" Jam Nut
Thread the nuts on just fl ush with the end of the
cable. Repeat on the passenger's side.
NOTE: Final adjustment of the cables will
take place in the Operational Test and Final
Adjustments section of this document.
Lit. No. 52308, Rev. 06
INSTALLATION INSTRUCTIONS
1/4" x 1-1/2"
Cotter Pin
Cable
3/4" Hex Nut
9. Stand the blade and A-frame assembly upright and
support it in a level position using a block under the
main A-frame tube. Install the blade guides using
5/16" x 1" cap screws and 5/16" locknuts.
Blade
Guide
5/16" x 1"
Cap Screws
8
5/16"
Locknuts
May 1, 2021