FOLLO FUTURA FOLLO STABILIS MANUPED Manuel - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} FOLLO FUTURA FOLLO STABILIS MANUPED. FOLLO FUTURA FOLLO STABILIS MANUPED 13 pages.
Imprimer la page
The purpose of the training
The Manuped machine is designed to improve circulation. It can be used standing on the
floor (as shown in the illustration on the cover) while the patient sits on a chair/wheelchair,
which has been placed on the floor plates (to keep the machine steady and in position
during use). Select a resistance that the patient can keep up for at least 15 minutes. Start
pedalling using even movements, extending movements as far as possible. Read off time
and distance on the counter.
Safety information
Make sure that nothing can be pinched or jammed and that the handles and pedals
rotate easily and are properly secured. Avoid using very loose clothing, which could
get caught up in the belt, handles or pedals.
Always test the machine's functions yourself, and allow the patient to test all functions
under supervision before handing out the product for self-training.
Unpacking
3.
Take care when removing
the machine from its
packaging. Do NOT use a
knife or other sharp
instrument as this may
damage the machine.
Inspect the machine for any
transport damage.
4.
Place the machine on the
floor as shown in the
drawing. Stand on the floor
plates A) and press in the
lever (B) to release the gas-
assisted spring. The gas-
assisted spring will now push the machine upwards at low pressure. See also item 5
GUIDELINES FOR USE.
Guidelines for use
1. Use: The Manuped is designed for use standing on the floor while the user sits on a
chair/wheelchair placed on the floor plates. Make sure that the chair is pushed well onto
the floor plates.
2. Adjusting resistance: Adjust resistance using the
levers (1). Rotating the levers in a clockwise
direction increases reistance, and loosening anti-
clockwise reduces resistance.
3. Adjusting the length of handles and pedals:The crank
throw of the handles and pedals may be adjusted by first
loosening the knob (2). Pull out the lockpin (3) and push or
pull the handle or pedal to the required position. Make sure
that the lockpin (3) lines up with a hole and replace the
lockpin. Tighten the knob (2).
4. Counter: The counter (5) is a bicycle computer. It registers
when training starts, and is switched on automatically (at the
same function as when it was last used). Use the button (6)
on the bicylcle computer to switch between the different
functions: Distance, time, speed, clock and auto (changes
regularly between all functions). Holding down button (6) will
clear time and distance (not the clock). The computer will
switch off automatically when not in use for a period. Read
more about the bicycle computer's functions in the separate
instructions for use.
5. Adjustment of upper section: The upper section of the
Manuped can be adjusted to the required position (or
folded away) by pressing down (7) at the top of the gas-
assisted spring (8) and at the same time holding the top
of the machine near the counter (the gas-assisted spring
will push the section upwards at low pressure). By
pushing downwards or releasing, the position of the unit
can be adjusted up or down. When you have found the
best posiltion, release handle (7) and the machine is
ready for use.
6. Floor plates: Adjustable inwards and outwards by
loosening knob (9). Adjust to required position and tighten
knob (9).
08/08/18
Side 7
rev: 18