FOLLO FUTURA FOLLO STABILIS MANUPED 매뉴얼 - 페이지 7

{카테고리_이름} FOLLO FUTURA FOLLO STABILIS MANUPED에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FOLLO FUTURA FOLLO STABILIS MANUPED 13 페이지.

페이지 인쇄

The purpose of the training

The Manuped machine is designed to improve circulation. It can be used standing on the

floor (as shown in the illustration on the cover) while the patient sits on a chair/wheelchair,

which has been placed on the floor plates (to keep the machine steady and in position

during use). Select a resistance that the patient can keep up for at least 15 minutes. Start

pedalling using even movements, extending movements as far as possible. Read off time

and distance on the counter.

Safety information



Make sure that nothing can be pinched or jammed and that the handles and pedals

rotate easily and are properly secured. Avoid using very loose clothing, which could

get caught up in the belt, handles or pedals.



Always test the machine's functions yourself, and allow the patient to test all functions

under supervision before handing out the product for self-training.

Unpacking

Take care when removing

the machine from its

packaging. Do NOT use a

knife or other sharp

instrument as this may

damage the machine.

Inspect the machine for any

transport damage.

Place the machine on the

floor as shown in the

drawing. Stand on the floor

plates A) and press in the

lever (B) to release the gas-

assisted spring. The gas-

assisted spring will now push the machine upwards at low pressure. See also item 5

GUIDELINES FOR USE.

Guidelines for use

1. Use: The Manuped is designed for use standing on the floor while the user sits on a

chair/wheelchair placed on the floor plates. Make sure that the chair is pushed well onto

the floor plates.

2. Adjusting resistance: Adjust resistance using the

levers (1). Rotating the levers in a clockwise

direction increases reistance, and loosening anti-

clockwise reduces resistance.

3. Adjusting the length of handles and pedals:The crank

throw of the handles and pedals may be adjusted by first

loosening the knob (2). Pull out the lockpin (3) and push or

pull the handle or pedal to the required position. Make sure

that the lockpin (3) lines up with a hole and replace the

lockpin. Tighten the knob (2).

4. Counter: The counter (5) is a bicycle computer. It registers

when training starts, and is switched on automatically (at the

same function as when it was last used). Use the button (6)

on the bicylcle computer to switch between the different

functions: Distance, time, speed, clock and auto (changes

regularly between all functions). Holding down button (6) will

clear time and distance (not the clock). The computer will

switch off automatically when not in use for a period. Read

more about the bicycle computer's functions in the separate

instructions for use.

5. Adjustment of upper section: The upper section of the

Manuped can be adjusted to the required position (or

folded away) by pressing down (7) at the top of the gas-

assisted spring (8) and at the same time holding the top

of the machine near the counter (the gas-assisted spring

will push the section upwards at low pressure). By

pushing downwards or releasing, the position of the unit

can be adjusted up or down. When you have found the

best posiltion, release handle (7) and the machine is

ready for use.

6. Floor plates: Adjustable inwards and outwards by

loosening knob (9). Adjust to required position and tighten

knob (9).

08/08/18

Side 7

rev: 18