DPCAV PANDORA Manuel - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} DPCAV PANDORA. DPCAV PANDORA 7 pages. Pan & tilt kit

Bottom Mount (Under-Carriage) Assembly:

Note: Carefully review the photos shown below for details to the following assembly steps.

Install the HS-65HB (or generic 9-Gram) servo on the chassis's side panel (item 2) using two

2-56 x 3/8" machine screws and nuts, as well as the grommets supplied with the servo. Be

sure to apply Threadlocker to the threads.

Using two 2-56 nuts (with Locktite), install

the tilt plate (item 9) onto the main chassis.

Do NOT tighten the axle nuts. Verify

correct axle placement so that the tilt plate

can smoothly swing up and down. Please

note that this configuration uses the

forward axle mounting holes, as seen in

Figure 10.

If a HS-65HB servo is used, then install its

one-inch long nylon arm. Alternate: When

a generic 9-gram servo is used, the red

servo arm (item 11) is installed on the

servo's nylon wheel. Drill the wheel's holes

with a 0.064" bit and install the red arm

with two 2-56 x 1/4" self tapping screws.

Please see Figure 10 for details.

Install a DuBro mini EZ pushrod connector on the arm (drill a hole for the EZ using a 0.060"

bit). Please note that the "lower" pushrod hole is used in this configuration.

Install the pushrod as shown in the photos. The Z-bend end is placed on the Tilt panel side.

Warning: The servo arm position must be made with care to prevent damage to the servo

when it travels to its extreme positions. It will be necessary to adjust your R/C system's

EPA/ATV mix for the proper servo range.

Figure 12, Camera Full Forward

(

), www.dpcav.com

ANDORA

REV-C

Figure 11, "Bottom" Mount Details

Figure 13, Camera Full Down

Page 5