amsbio Ozilla AMS.E4002GD Manuel de démarrage rapide - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} amsbio Ozilla AMS.E4002GD. amsbio Ozilla AMS.E4002GD 6 pages.

Imprimer la page

III. Turning the Instrument On

Press power

button for three seconds: red alarm light/audible beep will come on briefly followed by a warm up cycle as follows:

Figure 3:

initial screen

The instrument will start a warm-up cycle with a count down from "60" to "0.00". During this phase, the circulation pump will start and

continue to work until the

during detector operation.

At the end of warm-up, the unit will emit an audible beep and the alarm light will flash briefly, then the screen will start displaying a

rotating fan symbol (Figure 5); this "ready screen" indicates the instrument is now ready to measure ozone gas levels.

Use the Ozilla Ozone Gas Detector to detect ozone gas levels in rooms or cabinets where the Ozilla Ozone Sterilizer device is

operating, or in general to check ozone presence in desired areas. To detect gas levels, point the device intake nozzle (Figure 1)

towards the area where ozone gas is suspected. It is recommended that users try the Ozilla Ozone Gas Detector in ozone-free areas

to get background readings and possibly to zero the instrument if needed (Section III.1)

NOTE: to avoid false positive ozone readings, avoid areas or surfaces containing relatively high alcohol or chemical vapor content.

Brief background readings of up to 0.2 ppm are normal and should not cause alarm. Any sustained (10 minutes or more) readings of

over 0.5 ppm ozone gas should be investigated and remedied.

IV. Menu Settings and Adjustments

A. MAIN MENU MODE: To enter the menu mode, press the [OK] button for 3 seconds. The following screen appears

MAIN MENU

•

Basic Set

•

History data

•

Data Analyse

•

Zero cali

•

Range cali

•

Alarm param

•

DETC&STOR SET

•

Date Time

•

Reset factory

B. BASIC SETUP: To enter this mode, press the down button to highlight the "Basic Set" option, then press [OK] button. The following

screen is displayed:

Basic Set

• Range&Unit

• Channel Set

• Address Set

• Bump Flow

• Tempr cor

• Humid cor

• Language

English

To change a particular option, navigate with the up

detector proper functioning, It is neither needed nor recommended to make any changes to the Basic Setup options. Available

Ozilla® Ozone Gas Detector Pro

Figure 4: Detector warms up by

counting down from 60 to 0 seconds

button is pressed, or until the detector is turned off. Do not block either intake or exhaust ports

RUN

STOP

Main menu visible screen is highlighted with a

thick border. Use the down

selections below the highlighted box,

Basic Setup initial screen view in highlighted

with a thick border. Use the down

255

view selections below the highlighted box,

Figure 5:

instrument is ready to detect ozone gas

button to view

button to

or down

buttons to the desired item, then press the [OK] button. For

"ready screen" indicates