Electrolux 807650601 Manuel d'utilisation et d'entretien - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Electrolux 807650601. Electrolux 807650601 39 pages.
Imprimer la pageinstallation
7
Freezer Drawer Alignment (_n_,.rj)
1
Check gasket seal around top, bottom, and sides
of freezer drawer.
2
If gasket is not sealed, open drawer and slightly
loosen four drawer screws (two on each side) to
allow drawer to rotate.
3
Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B). Be careful not to rotate the drawer.
To level the cabinet using the front rollers:
1 Slightly open freezer drawer. Lift the toe grille and
gently pull forward (see illustration).
2
"Youcan raise or lower each door. Use a 3is inch
socket wrench to turn the adjustment screws
(1 per side).
4
5
Recheck gasket seal.
Push
Against
_-
Tighten four drawer screws.
Head
Grab
Drawer
At Center
From
Both
Sides
Then
Pull Drawer
Out
Cabinet
Leveling & Refrigerator
Door
AMignment (Hne°e® o j)
Guidelines for final positioning of your refrigerator:
,, All four corners of the cabinet must rest firmly on
the floor,
,, The sides should tilt 1/4inch (6 mm) from front
to back (to ensure that doors close and seal
properly).
,, Doors should align with each other and be level.
Most of these conditions can be met by raising or
lowering the adjustable front rollers.
3
4
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw counterclockwise.
Ensure both doors are bind-free with their seals
touching the cabinet on all four sides and that
cabinet is stable.
After unit is leveled, lower anti-tip leg until it
contacts the floor.
_owe r
5
nsta the toe grille by fitting into place.