Electrolux 807650601 사용 및 관리 매뉴얼 - 페이지 7
{카테고리_이름} Electrolux 807650601에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 807650601 39 페이지.
페이지 인쇄installation
7
Freezer Drawer Alignment (_n_,.rj)
1
Check gasket seal around top, bottom, and sides
of freezer drawer.
2
If gasket is not sealed, open drawer and slightly
loosen four drawer screws (two on each side) to
allow drawer to rotate.
3
Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B). Be careful not to rotate the drawer.
To level the cabinet using the front rollers:
1 Slightly open freezer drawer. Lift the toe grille and
gently pull forward (see illustration).
2
"Youcan raise or lower each door. Use a 3is inch
socket wrench to turn the adjustment screws
(1 per side).
4
5
Recheck gasket seal.
Push
Against
_-
Tighten four drawer screws.
Head
Grab
Drawer
At Center
From
Both
Sides
Then
Pull Drawer
Out
Cabinet
Leveling & Refrigerator
Door
AMignment (Hne°e® o j)
Guidelines for final positioning of your refrigerator:
,, All four corners of the cabinet must rest firmly on
the floor,
,, The sides should tilt 1/4inch (6 mm) from front
to back (to ensure that doors close and seal
properly).
,, Doors should align with each other and be level.
Most of these conditions can be met by raising or
lowering the adjustable front rollers.
3
4
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw counterclockwise.
Ensure both doors are bind-free with their seals
touching the cabinet on all four sides and that
cabinet is stable.
After unit is leveled, lower anti-tip leg until it
contacts the floor.
_owe r
5
nsta the toe grille by fitting into place.