Electrolux Built-In Dishwasher Manuel d'instructions d'installation - Page 10

2. Cut water access hole in cabinet as shown in Figure 3.

3. Route water supply line to installation area.

NOTE

Incoming hot water temperature, set at the hot water heater, should be 120° F (49° C). Water

pressure should be between 20-120 psi.

MAKING THE DRAIN CONNECTION

CAUTION

To prevent siphoning, an air gap MUST BE USED when waste tee or disposer connection

is less than 18" above the floor to prevent siphoning. Failure to provide the proper drain

connection using an air gap or a 30" minimum high drain loop will result in improper

draining and may cause property damage or poor wash performance.

1. Follow local codes and ordinances.

2. Review Figure 4 and Figure 5, page 12 to see the different ways to connect

dishwasher to drain system. Choose the method that best suits your need.

3. If you connect to a sink drain, entry will need to be above the trap. A "Y"

branch tailpiece and connector kit, not included, will make this method easier

and included all needed ﬁttings and instructions. See Figure 5, page 12.

Making the Connections

Through Cabinet

Entry Must be Above Trap

Figure 4

Sink at Left

Figure 3

Y-Branch

Tailpiece

Sink at Right

2" Drain Hose Hole