Electrolux Built-In Dishwasher Panduan Petunjuk Instalasi - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Kulkas Electrolux Built-In Dishwasher. Electrolux Built-In Dishwasher 28 halaman. Built-in oven
Juga untuk Electrolux Built-In Dishwasher: Panduan Penggunaan dan Perawatan (36 halaman), Panduan Penggunaan & Perawatan (44 halaman), Panduan Penggunaan & Perawatan (28 halaman), Panduan Penggunaan & Perawatan (40 halaman), Panduan Penggunaan & Perawatan (27 halaman), Panduan Penggunaan & Perawatan (12 halaman), Panduan Penggunaan & Perawatan (22 halaman), Tips dan Resep (36 halaman), Panduan Petunjuk Pengoperasian (18 halaman), Panduan Pengguna Ower (21 halaman), Panduan Pengguna Ower (13 halaman), Panduan Pemilik (29 halaman), Panduan Pengguna (27 halaman), Buku Instruksi (17 halaman), Buku Instruksi (15 halaman), Buku Petunjuk (18 halaman), Buku Instruksi (27 halaman), Buku Instruksi (18 halaman), Panduan Servis (50 halaman)

Electrolux Built-In Dishwasher Panduan Petunjuk Instalasi
2. Cut water access hole in cabinet as shown in Figure 3.
3. Route water supply line to installation area.
NOTE
Incoming hot water temperature, set at the hot water heater, should be 120° F (49° C). Water
pressure should be between 20-120 psi.
MAKING THE DRAIN CONNECTION
CAUTION
To prevent siphoning, an air gap MUST BE USED when waste tee or disposer connection
is less than 18" above the floor to prevent siphoning. Failure to provide the proper drain
connection using an air gap or a 30" minimum high drain loop will result in improper
draining and may cause property damage or poor wash performance.
1. Follow local codes and ordinances.
2. Review Figure 4 and Figure 5, page 12 to see the different ways to connect
dishwasher to drain system. Choose the method that best suits your need.
3. If you connect to a sink drain, entry will need to be above the trap. A "Y"
branch tailpiece and connector kit, not included, will make this method easier
and included all needed fittings and instructions. See Figure 5, page 12.
Making the Connections
Through Cabinet
Entry Must be Above Trap
Figure 4
Sink at Left
11
Figure 3
Y-Branch
Tailpiece
Sink at Right
2" Drain Hose Hole