Draper Clarion Instructions d'assemblage et de montage
Parcourez en ligne ou téléchargez le pdf Instructions d'assemblage et de montage pour {nom_de_la_catégorie} Draper Clarion. Draper Clarion 3 pages. Permanently tensioned projection screen
Également pour Draper Clarion : Instructions d'assemblage et de montage (2 pages), Instructions d'assemblage et de montage (4 pages), Instructions d'assemblage et de montage (4 pages), Instructions d'assemblage et de montage (2 pages)
Imprimer la page
Curved Clarion Permanently Tensioned Projection Screen by Draper
1 Read instructions through completely before proceeding.
2 Follow instructions carefully. Installation contrary to instructions
invalidates warranty.
3 When lifting assembled screen, do not lift at only one corner; lift at
both corners. Lifting by one corner could result in damage to the
screen frame, especially on large screens.
4 Screen should be accessible for complete removal should fabric become
damaged or should other service be required.
5 Screen should be installed level (using a carpenter's level).
6 Nothing should be fastened to screen frame or viewing surface.
7 Make sure you have received all parts (see parts list below and exploded
diagram on page 2).
8 Screwdriver required for screen assembly; drill and screwdriver needed
for attachment to wall.
9 The ideal temperature range for assembling folding screens to prevent
damaging the surface is 68°-78° F (20°-26° C). Assembling below
recommended temperatures may damage surface and void warranty.
NOTE: Screen has been thoroughly inspected and tested at factory and
found to be operating properly prior to shipment.
Clarion—Hardware and Parts List
Frame Extrusions - 4
Self-tapping
Screws-8
Surface Retention
Extrusions- varies
Viewing Surface - 1
Frame Preparation
1 Clean area and place frame assembly pieces face down. Snap plastic
corner pieces into ends of aluminum frame extrusions as indicated in
Figures 1 through 4.
Patented by Draper, Inc., U.S. Patent Nos. 6,785,047; 7,113,332; and 7,369,310.
®
Copyright © 2013 Draper Inc.
Form CurvedClarion_Inst13 Printed in U.S.A.
Assembly/Mounting Instructions
Caution
Corners - 4
Part No. C098.019
Plastic Tubing - 4
Brackets -
See last page of
instructions
Figure 1
2 Check to verify that all four (4) plastic corners are seated securely in
aluminum frame extrusion lengths (see Fig. 5). Lock in place using eight (8)
self-tapping screws.
Caution: Do not over-tighten fasteners—over-tightening could cause
damage to the frame corners.
If you encounter any difficulties installing or servicing your Clarion screen, call your
dealer or Draper, Inc., Spiceland, Indiana, (765) 987-7999; or fax (765) 987-7142.
Figure 2
Figure 3
Figure 4
Figure 5
(Continued on Page 2)