投影スクリーン Draper ClarionのPDF 組み立て/取り付け説明書をオンラインで閲覧またはダウンロードできます。Draper Clarion 3 ページ。 Permanently tensioned projection screen
Draper Clarion にも：組み立て/取り付け説明書 (2 ページ), 組み立て/取り付け説明書 (4 ページ), 組み立て/取り付け説明書 (4 ページ), 組み立て/取り付け説明書 (2 ページ)

ページを印刷する

Curved Clarion Permanently Tensioned Projection Screen by Draper

1 Read instructions through completely before proceeding.

2 Follow instructions carefully. Installation contrary to instructions

invalidates warranty.

3 When lifting assembled screen, do not lift at only one corner; lift at

both corners. Lifting by one corner could result in damage to the

screen frame, especially on large screens.

4 Screen should be accessible for complete removal should fabric become

damaged or should other service be required.

5 Screen should be installed level (using a carpenter's level).

6 Nothing should be fastened to screen frame or viewing surface.

7 Make sure you have received all parts (see parts list below and exploded

diagram on page 2).

8 Screwdriver required for screen assembly; drill and screwdriver needed

for attachment to wall.

9 The ideal temperature range for assembling folding screens to prevent

damaging the surface is 68°-78° F (20°-26° C). Assembling below

recommended temperatures may damage surface and void warranty.

NOTE: Screen has been thoroughly inspected and tested at factory and

found to be operating properly prior to shipment.

Clarion—Hardware and Parts List

Frame Extrusions - 4

Self-tapping

Screws-8

Surface Retention

Extrusions- varies

Viewing Surface - 1

Frame Preparation

1 Clean area and place frame assembly pieces face down. Snap plastic

corner pieces into ends of aluminum frame extrusions as indicated in

Figures 1 through 4.

Patented by Draper, Inc., U.S. Patent Nos. 6,785,047; 7,113,332; and 7,369,310.

Form CurvedClarion_Inst13 Printed in U.S.A.

Assembly/Mounting Instructions

Caution

Corners - 4

Part No. C098.019

Plastic Tubing - 4

Brackets -

See last page of

instructions

Figure 1

2 Check to verify that all four (4) plastic corners are seated securely in

aluminum frame extrusion lengths (see Fig. 5). Lock in place using eight (8)

self-tapping screws.

Caution: Do not over-tighten fasteners—over-tightening could cause

damage to the frame corners.

If you encounter any difficulties installing or servicing your Clarion screen, call your

dealer or Draper, Inc., Spiceland, Indiana, (765) 987-7999; or fax (765) 987-7142.

Figure 2

Figure 3

Figure 4

Figure 5

(Continued on Page 2)