FlexShade
®
5V Motor Stop Configuration
Turn Soft Stop OFF:
Motor must be in slowest speed to turn Soft Stop OFF.
Turn Soft Stop OFF: Motor must be in slowest speed to turn Soft Stop OFF.
Press P2 on
controller.
Motor Response
5V Motor Battery Check Function
Send Shade to battery charge level.
Send Shade to battery charge level.
IMPORTANT
Shade must be at Upper Limit.
Hold UP.
Shade must be at Upper Limit.
Motor Response
Hold UP for approx. 5 seconds.
Approx.
5
5V Motor Sleep Mode
If multiple motors are grouped on a single channel, Sleep Mode may be used
If multiple motors are grouped on a single channel, Sleep Mode may be used
to put all but 1 motor to sleep, allowing programming of just the one motor
to put all but 1 motor to sleep, allowing programming of just the one motor
that remains "Awake". See page 6 for detailed P1 functions.
that remains "Awake".
Enter Sleep Mode
Sleep mode is utilized to
prevent a motor from incorrect
configuration during other
motor setup.
Hold P1 button on the motor head.
Motor Response
Approx.
6
Recharge
Press DOWN.
Press DOWN.
Motor Response
Motor Response
Upper Limit
Percentage of
Battery Charge
Lower Limit
Percentage Depleted
Shade moves to percentage
of battery charge remaining
Exit Sleep Mode:
Exit Sleep Mode:
Method 1
Method 2
Exit sleep mode once
Remove power and then
the shade is ready.
re-power the motor.
Press and release P1 button
on the motor head.
Motor Response
Turn Soft Stop ON:
Motor must be in fastest speed to turn Soft Stop ON.
Turn Soft Stop ON: Motor must be in fastest speed to turn Soft Stop ON.
Press P2 on
controller.
Motor Response
5V Motor Charging LED
Turn Charging LED ON/OFF
Turn Charging LED ON/OFF
IMPORTANT
Shade must be at Lower Limit.
Remaining
5V Motor Troubleshooting
PROBLEM
Motor is not
responding
Motor beeps
x10 when in use
Cannot program
a single motor
(multiple motors
respond)
Press UP.
Motor Response
Hold DOWN
Hold DOWN
to toggle off.
to toggle on.
Motor Response
Motor Response
Approx.
Approx.
5
Red LED flashes 3x
Red LED flashes 3x
CAUSE
Recharge with a compatible
Battery in motor is depleted
charger
Insufficient charging from
Check connection and
solar PV panel
orientation of PV panel
Transmitter battery is
Replace battery
discharged
Battery is inserted
Check battery polarity
incorrectly into transmitter
Ensure transmitter is
positioned away from metal
Radio interference/shielding
objects and the aerial on
motor or receiver is kept
straight and away from metal
Receiver distance is too far
Move transmitter to a closer
from transmitter
position
Check power supply to motor
Charging failure
is connected and active
Recharge with a compatible
Battery voltage is low
charger
Always reserve an individual
Multiple motors are paired
channel for programming
to the same channel
functions. Use Sleep Mode to
program individual motors.
page 10 of 11
Press UP.
Motor Response
5
REMEDY
Imprimer la page