Draper FlexShade Instructions d'installation et d'utilisation - Page 8

Parcourez en ligne ou téléchargez le pdf Instructions d'installation et d'utilisation pour {nom_de_la_catégorie} Draper FlexShade. Draper FlexShade 11 pages. Exterior clutch-operated shade
Également pour Draper FlexShade : Manuel d'installation et d'utilisation (8 pages), Instructions d'installation (2 pages), Manuel d'instructions (12 pages), Instructions Installation et fonctionnement (12 pages), Instructions Installation et fonctionnement (16 pages), Instructions Installation et fonctionnement (4 pages), Manuel d'instructions (7 pages), Instructions Installation et fonctionnement (12 pages), Instructions Installation et fonctionnement (16 pages)

Imprimer la page
Draper FlexShade Instructions d'installation et d'utilisation
FlexShade
®

Section 10 - 5 Volt Motor Limits

IMPORTANT
Cycle shade up and down
prior to setting limits
to settle fabric.
IMPORTANT
Damage to shade may occur
when operating motor prior
to setting limits.
Atttention should be given.
Setting 5 Volt Motor Limits
IMPORTANT
Cycle shade up and down prior to setting
limits to settle fabric.
Move shade to the desired
highest or lowest position by
pressing the UP or DOWN
buttons on controller.
OR
IMPORTANT
After setting limits, motor
will automatically
exit from initial setup mode.
Using P2 Button on existing controller to add a
new controller or channel
A = Existing controller or channel
(to keep)
B = Controller or channel to add or remove
Press P2 on
Press P2 on
controller A.
controller A.
A
Motor Response
Motor Response
IMPORTANT
Consult user manual for your controller or sensor.
Recharge
OR
Quick Press = Step
Long Press = Continuous
To save upper limit,
hold UP and STOP.
To save lower limit,
hold DOWN and STOP.
Motor Response
Approx.
5
Press P2 on
controller B
to add it.
A
B
Motor Response
To reverse shade direction,
hold both UP and DOWN
until the motor responds.
Motor Response
Approx.
Travel
Adjusting 5 Volt Motor Limits
To adjust upper limit:
Hold UP & STOP for 1 jog & 1 beep.
Move shade to new upper limit.
Hold UP & STOP for 2 jogs & 3 beeps.
Motor Response
IMPORTANT
The bottom limit should be set ~ 1.38 in.
disengage the auto lock mechanism when the shade is raised.
Using an existing controller
to add or delete a controller or channel
A = Existing controller or channel
B = Controller or channel to add or remove
Press P2 on
controller A.
A
Motor Response
IMPORTANT
Consult user manual for your controller or sensor.
page 8 of 11
IMPORTANT
Reversing motor direction
using this method is only possible
during initial set-up.
To adjust lower limit:
Hold DOWN & STOP for 1 jog & 1 beep.
Move shade to new lower limit.
Hold DOWN & STOP for 2 jogs & 3 beeps.
OR
Motor Response
Approx.
5
below the Ultra-Lock to
(35mm)
(to keep)
Press P2 on
controller A.
A
Motor Response
Motor Response
Press P2 on
controller B
to remove it.
B