Bottom-Up FlexShade
Small and Large Hardware
Section 13 - Bead Chain Limits and Safety Device Installation
Attaching Stop Balls
1. Set upper and lower travel limits by installing stop balls to bead chain
Caution: Be sure to use stop balls provided in hardware packet by Draper to set up and down travel
limits. Stop balls by others may be too small, and become lodged in clutch mechanism.
P-Clip Cord Tension Device
Please Note: Draper
Bead Chain Clutch-Operated shades that do not comply with WMCA/ANSI Standard
®
A100.1-2012 come with a P-Clip cord tension device pre-attached to bead chain
must be attached to wall, jamb, or sill so that bead chain is held taut enough that children cannot pull it
away from wall or fit their head into loop.
Spring-Loaded Cord Tension Device
If Draper Clutch FlexShade
complies with WMCA/ANSI Standard A100.1-2018, a Spring-Loaded Cord
®
Tension Device comes installed on bead chain
mechanical fasteners
(wood screws)
away from wall or fit their head into loop.
For more information, visit www.draperinc.com/WindowShades/WCMAcompliance.asp.
1. Pull tensioner down so that bead chain is held taut and use mounting hardware to keep it taut.
2. Install cord tension device to wall, jamb, or sill.
Please Note: Bead chain should be taut enough to move smoothly through device. However, overtightening
screws will damage Spring-Loaded Tension Device.
Section 14 - Dimensions
C*
B*
Dimension
X**
Y**
Dimension
X***
Y***
*These dimensions are different for each shade and are provided by Draper
Dimension "A" is a vertical cable spacing.
Dimension "B" is the distance from the vertical cable spacing to the vertical edge of the shade.
Dimension "C" is the distance from the Idler End of the tube to the center of the cable attachment stud.
Dimension "D" is the distance from the Operator End of the tube the center of the cable attachment stud.
**These dimensions apply to Endcap Covers. Endcap or Fascia dimensions fall within this dimension.
***Shades with Headbox are " larger.
NEXD,
®
. An approved permanent warning label and approved
(Fig. 13-C)
are included. Device is designed so that children cannot pull bead chain
.
(See safety note on page 2)
A*
Large Hardware
4 "
(117mm)
4 "
(117mm)
Large Hardware
w/ Headbox
4 "
(119mm)
4 "
(119mm)
Shade Width=Cloth Width + 1 "
.
(crimp closed using pliers) (Fig. 13-A)
. This device
(Fig. 13-B)
D*
B*
Small Hardware
3 "
(86mm)
3 "
(98mm)
Small Hardware
w/ Headbox
3 "
(87mm)
3
"
(98mm)
(41mm)
with your order.
®
page 10 of 10
Figure 13-A
CHAIN LIMITS
1. Attach
stop balls.
2. Crimp
closed
with
pliers.
Figure 13-C: CHAIN TENSION DEVICE
Sill
Mount
Tensioner
X
Y
Y
X
Figure 13-B
P-CLIP
P-Clip
Jamb
Mount
Imprimer la page