Dual Roller FlexShade
Section 6 - Attaching Fascia
STEP 1:
STEP 2:
Click fascia
into place
Section 7 - Bead Chain Limits and Safety Device Installation
Attaching Stop Balls
1. Set upper and lower travel limits by installing stop balls to bead chain
P-Clip Cord Tension Device
Please Note: Draper
Bead Chain Clutch-Operated shades that do not comply with WMCA/ANSI Standard A100.1-2012
®
come with a P-Clip cord tension device pre-attached to bead chain
jamb, or sill so that bead chain is held taut enough that children cannot pull it away from wall or fit their head into loop.
Spring-Loaded Cord Tension Device
If Draper Clutch FlexShade complies with WMCA/ANSI Standard A100.1-2018, a Spring-Loaded Cord Tension Device
comes installed on bead chain
(Fig. 7-C)
are included. Device is designed so that children cannot pull bead chain away from wall or fit their head into loop.
screws)
. For more information, visit www.draperinc.com/windowshades/wcmacompliance.aspx.
(See safety note on page 2)
1. Install cord tension device to wall, jamb, or sill.
2. Pull tensioner down so that bead chain is held taut and use mounting hardware to keep it taut.
Please Note: Bead chain should be taut enough to move smoothly through device. However, overtightening screws will
damage Spring-Loaded Tension Device.
NEXD
®
(Fig. 7-B)
. An approved permanent warning label and approved mechanical fasteners
STEP 2:
Click fascia
.
(crimp closed using pliers) (Fig. 7-A)
. This device must be attached to wall,
page 8 of 12
Fascia seats
on projections
on endcaps.
into place
!
Fascia is not fully
seated until it
clicks into place
on both ends.
Once in place,
check for
secure fit.
Chain Limits
1. Attach
stop balls.
2. Crimp
closed
with
pliers.
Figure 7-A
Chain Tension Device
(wood
Sill
Mount
Figure 7-C
P-Clip
P-Clip
Figure 7-B
Jamb
Mount
Tensioner
Imprimer la page