Draper 65084 Manuel d'instructions original - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions original pour {nom_de_la_catégorie} Draper 65084. Draper 65084 20 pages. Dual action air composite sander
Également pour Draper 65084 : Manuel de l'utilisateur (16 pages)
Imprimer la page
6. Preparation Instructions
6.3 Connection to the Air Supply
Important: Draper Tools recommends using a 1/4" BSP
male-threaded thread whip hose (Stock No. 54438,
not supplied) to connect the spray gun to an air line in
order to reduce vibration.
WARNING! To prevent unintentional starting,
ALWAYS ensure that the retaining clip is
installed and that the trigger lever is not
depressed while connecting the air line.
1. Wrap a length of PTFE tape around the air line
coupling (B) or whip hose thread.
Important: For a more secure seal, the PTFE tape
should be wrapped in the opposite direction to
the thread.
2. Remove the inlet bung (5) and screw the air line
coupling or whip hose into the tool air line inlet (1).
Fig.
2
3. Connect the air line to the air line coupling or
whip hose.
4. Pressurise the air line when you are ready to begin.
6.4 Attaching Sanding Pads
Important: ALWAYS ensure that the air line is
disconnected before installing, adjusting or removing
sanding pads.
This product is compatible with hook-and-loop-backed
sanding pads.
To install a sanding pad, align the edges and holes
of the sheet with the backing plate and press it firmly
into place.
(B)
(5)
(1)
Fig.
3
Sanding pads should be replaced when they become
damaged, excessively worn or fail to ware the workpiece
appropriately during use.
Important: If the sanding pad is not punched, use a
suitable tool to pierce the sheet in line with the backing
plate openings. This allows dust to be extracted from the
workpiece and reduces the risk of inhalation.
CAUTION! The sanding pad MUST be suitably
sized for the backing plate. Use of over- or
under-sized pads may cause significant damage
to the backing plate or spindle.
6.5 Dust Extraction
Important: To reduce the risk to health, ALWAYS use
appropriate dust extraction facilities when working with
this tool.
Firmly insert a suitable dust extraction hose
(not supplied) into the dust outlet (3) and attach the
other end of the hose to an appropriate dust extractor.
Fig.
4
– 11 –
EN
(3)