Draper 65084 Orijinal Talimat Kılavuzu - Sayfa 11

Sander Draper 65084 için çevrimiçi göz atın veya pdf Orijinal Talimat Kılavuzu indirin. Draper 65084 20 sayfaları. Dual action air composite sander
Ayrıca Draper 65084 için: Kullanıcı Kılavuzu (16 sayfalar)

Sayfayı Yazdır

6. Preparation Instructions

6.3 Connection to the Air Supply

Important: Draper Tools recommends using a 1/4" BSP

male-threaded thread whip hose (Stock No. 54438,

not supplied) to connect the spray gun to an air line in

order to reduce vibration.

WARNING! To prevent unintentional starting,

ALWAYS ensure that the retaining clip is

installed and that the trigger lever is not

depressed while connecting the air line.

1. Wrap a length of PTFE tape around the air line

coupling (B) or whip hose thread.

Important: For a more secure seal, the PTFE tape

should be wrapped in the opposite direction to

the thread.

2. Remove the inlet bung (5) and screw the air line

coupling or whip hose into the tool air line inlet (1).

Fig.

3. Connect the air line to the air line coupling or

whip hose.

4. Pressurise the air line when you are ready to begin.

6.4 Attaching Sanding Pads

Important: ALWAYS ensure that the air line is

disconnected before installing, adjusting or removing

sanding pads.

This product is compatible with hook-and-loop-backed

sanding pads.

To install a sanding pad, align the edges and holes

of the sheet with the backing plate and press it firmly

into place.

(B)

(5)

(1)

Fig.

Sanding pads should be replaced when they become

damaged, excessively worn or fail to ware the workpiece

appropriately during use.

Important: If the sanding pad is not punched, use a

suitable tool to pierce the sheet in line with the backing

plate openings. This allows dust to be extracted from the

workpiece and reduces the risk of inhalation.

CAUTION! The sanding pad MUST be suitably

sized for the backing plate. Use of over- or

under-sized pads may cause significant damage

to the backing plate or spindle.

6.5 Dust Extraction

Important: To reduce the risk to health, ALWAYS use

appropriate dust extraction facilities when working with

this tool.

Firmly insert a suitable dust extraction hose

(not supplied) into the dust outlet (3) and attach the

other end of the hose to an appropriate dust extractor.

Fig.

– 11 –

(3)