Electrolux 400 SERIES Manuel d'utilisation et d'entretien - Page 23
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Electrolux 400 SERIES. Electrolux 400 SERIES 28 pages. Front load dryer
Également pour Electrolux 400 SERIES : Manuel d'utilisation et d'entretien (16 pages), Manuel d'utilisation et d'entretien (39 pages), Manuel d'instructions d'installation (50 pages), Manuel d'utilisation et d'entretien (46 pages)
Imprimer la page
Solutions to Common Inquiries
Common Drying Inquiries
Many drying problems involve poor cleaning results, poor soil and stain removal, resi-
dues of lint and scum, and fabric damage. For satisfactory drying results, follow these
suggestions provided by The Soap and Detergent Association.
PROBLEM POSSIBLE
CAUSES
Greasy, oily
• Fabric softener
stains
sheet
Lint
• Overloading
• Overdrying
causes static
electricity
• Lint screen not
clean when
cycle began
• Lint is attached
to "pills"
Pilling
• Overdrying
(fibers
break off,
ball up and
cling to
fabric)
Shrinking
• Temperature
too high
• Overdrying
Wrinkling
• Overloading
• Leaving items
in dryer after
cycle ends
Isolated wet
• Low water
spots on
pressure in
fabrics after
home is not
completed
sufficient to at-
Steam
omize incoming
cycle
water during
steam cycle
SOLUTIONS
• Rub fabric softener
stains with bar soap.
Rinse and rewash.
• Reduce load size
and rewash using
liquid fabric softener
in the final rinse.
• Or, add a fabric
softener sheet and
tumble without heat.
• Use lint brush or
roller to remove lint.
• Use a lint brush or
shaver to remove
pills.
• Irreversible
condition.
• Reduce load size
and tumble at me-
dium or low heat for
5-10 minutes.
• Remove items im-
mediately. Hang or
fold.
• Check water line
pressure.
PREVENTIVE
MEASURES
• Add a few bath towels
to small loads for proper
tumbling.
• Some "silk-like" fabrics
should be air dried.
• Use proper drying tem-
perature.
• Place fabric softener sheet
on top of load before start-
ing the dryer.
• DO NOT overload dryer.
• Use fabric softener in
washer or dryer to reduce
static electricity.
• Remove items when they
are slightly damp to avoid
overdrying.
• Check that lint filter is
clean and in place.
• Use fabric softener to
lubricate fibers.
• When ironing, use spray
starch or fabric finish on
collars and cuffs.
• Turn items inside out to
reduce abrasion.
• Follow fabric care label
directions.
• If shrinking is a concern,
check load often.
• Remove items while slight-
ly damp and hang or lay
flat to complete drying.
• Block knits into shape.
• DO NOT overload dryer.
• Remove items as soon as
cycle ends.
• Ensure water line pressure
is minimum of 20 psi. DO
NOT exceed 120 psi.
23